ECD SYSTEM(w/ Urea SCR System), Diagnostic DTC:P2195

DTC Code DTC Name
P2195 Oxygen (A/F) Sensor Signal Stuck Lean (Bank 1 Sensor 1)

DESCRIPTION

Refer to DTC P0031 Click here.

P2195
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
After the engine is fully warmed up, the accelerator pedal is released for 10 seconds or more immediately after the vehicle is accelerated to a speed of between 60 and 80 km/h (37 and 50 mph).

While fuel-cut operation performed (during vehicle deceleration), air fuel ratio sensor voltage is 2.12 V or more for 3.5 seconds

(2 trip detection logic)

  • Air fuel ratio sensor

  • ECM

MONITOR DESCRIPTION

When the air fuel sensor output indicates a lean value due to a malfunction in the sensor, the system cannot determine whether the air fuel ratio is rich and particulate matter may build up excessively in the DPF catalyst. The ECM monitors the air fuel ratio sensor voltage value when a fuel-cut is performed and detects whether this voltage value is abnormal. When the air fuel ratio sensor voltage value is 2.12 V or higher for 3.5 seconds or more, the ECM determines that the air fuel ratio sensor is malfunctioning and stores DTC P2195.

CAUTION / NOTICE / HINT

Note

After replacing the ECM, the new ECM needs registration (See page ) and initialization Click here.

Tech Tips

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. REPLACE AIR FUEL RATIO SENSOR


    1. Replace the air fuel ratio sensor Click here.


    NEXT

  2. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Start the engine.

    3. Turn the GTS on.

    4. Clear the DTCs Click here.

    5. Turn the engine switch off and wait for 30 seconds or more.

    6. Start the engine and warm it up.

    7. After the engine is fully warmed up, the accelerator pedal is released for 10 seconds or more immediately after the vehicle is accelerated to a speed of between 60 and 80 km/h (37 and 50 mph).

      CAUTION:

      When performing the confirmation driving pattern, obey all speed limits and traffic laws.

    8. Turn the GTS on.

    9. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    10. Read the DTCs.

      Tech Tips

      Perform the following procedure using the GTS to determine whether or not the DTC judgment has been carried out.


      1. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.

      2. Input DTC P2195.

      3. Check the DTC judgment result.

        Result
        GTS Display Result Proceed to
        Pending DTC DTC P2195 is output B
        All Readiness NORMAL A
        ABNORMAL B

        Tech Tips

        If STATUS is INCOMPLETE or N/A, the accelerator pedal is released for 10 seconds or more immediately after the vehicle is accelerated to a speed of between 60 and 80 km/h (37 and 50 mph) again.


    A

    END

    B

    REPLACE ECM Click here