POWER STEERING OIL PRESSURE SWITCH INSTALLATION

PROCEDURE

1. INSTALL POWER STEERING OIL PRESSURE SWITCH

   
   

   1. Install a new O-ring to the oil pressure switch.

   2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.

   3. Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque:

      21 N*m  { 210 kgf*cm, 15 ft.*lbf }

      Note

      
      

      • Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (surface which contacts the pressure feed tube).

      • Be careful not to damage the O-ring when installing the power steering oil pressure switch

   4. Connect the oil pressure switch connector.

2. ADD POWER STEERING FLUID

3. INSPECT FOR POWER STEERING FLUID LEAK

4. BLEED POWER STEERING FLUID

   Click here