CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL CRANKSHAFT POSITION SENSOR

   
   

   1. Apply a light coat of engine oil to the O-ring of the sensor.

      Note

      
      

      • When reusing the sensor, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the sensor.

   2. Install the sensor with the bolt.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

   3. Connect the sensor connector.

2. INSTALL IDLER PULLEY ASSEMBLY (w/o Air Conditioning System)

   
   

   1. Install the idler pulley with the 3 bolts.

      Torque:

      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

   Click here

4. INSTALL COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)

   
   

   1. Install the cooler compressor Click here.

5. INSTALL GENERATOR ASSEMBLY

   
   

   1. Install the generator Click here.