THROTTLE BODY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

for Automatic Transmission:

Perform "Inspection After Repairs" after replacing the throttle body with motor assembly Click here.

PROCEDURE


  1. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

    Tech Tips

    for Automatic Transmission:

    Perform "Inspection After Repairs" after replacing the throttle body with motor assembly Click here.


    1. Install a new gasket and the throttle body with motor with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Connect the throttle position sensor and throttle control motor connector.

    3. Connect the No. 4 water by-pass hose.

    4. Connect the No. 5 water by-pass hose.

  2. INSTALL NO. 1 AIR CLEANER HOSE

    Click here

  3. ADD ENGINE COOLANT

    Click here

  4. INSPECT FOR ENGINE COOLANT LEAK

    Click here

  5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT BUMPER COVER LOWER

    Click here

  7. INSTALL V-BANK COVER

    Click here

  8. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  9. PERFORM INITIALIZATION

    Note

    Perform the following procedure after replacing the throttle body with motor assembly or any throttle body components. The following procedure should also be performed if the throttle body with motor assembly is cleaned.


    1. for Manual Transmission:

      Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds, and then reconnect the fuses.

    2. Turn the engine switch on (IG) without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above steps again.

    3. Connect the intelligent tester to the DLC3 and clear the DTCs Click here.

    4. for Automatic Transmission:

      Perform "Inspection After Repairs" Click here.

    5. Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.

      Standard idle speed
      690 to 790 rpm

      Note


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in neutral.

    6. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

    7. Perform a road test and confirm that there are no abnormalities.