STARTER(for 3.0 kW Type) INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter assembly with the bolt and 2 nuts.

      Torque:

      68 N*m  { 693 kgf*cm, 50 ft.*lbf }

   2. Connect the starter wire with the nut.

      Torque:

      21 N*m  { 215 kgf*cm, 16 ft.*lbf }

   3. Connect the starter connector.

   4. Install the terminal cap.

2. INSTALL REAR ENGINE UNDER COVER ASSEMBLY

   Click here

3. INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

   
   

   1. Install the frame seal with the 5 clips.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.