STARTER(for 3.0 kW Type) REASSEMBLY

PROCEDURE


  1. INSTALL STARTER CLUTCH SUB-ASSEMBLY


    1. Apply high temperature grease to the steel ball, return spring, clutch roller, retainer, pinion gear and idler gear.

    2. A01XDHY

      Insert the steel ball into the starter clutch hole.

    3. Insert the return spring into the starter clutch hole.

    4. A01XGSCE04
      Text in Illustration
      *1 Return Spring
      *2 Idler Gear
      *3 Pinion Gear
      *4 Clutch Roller
      *5 Retainer
      *6 Starter Clutch
      *7 Starter Housing

      Install the starter clutch, return spring, idler gear, pinion gear, retainer and clutch roller.

    5. A01XD1M

      Install the starter housing to the magnet starter switch with the 3 screws.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  2. INSTALL STARTER ARMATURE ASSEMBLY


    1. A01XEYW

      Apply high-temperature grease to the armature bearings.

    2. Using a press, press the armature into the commutator end frame.

    3. Install a new O-ring to the starter yoke.

    4. A01XGSUE02
      Text in Illustration
      *1 Groove
      *2 Claw

      Align the groove of the commutator end frame with the claw of the starter yoke, and install the armature and commutator end frame.

  3. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    1. A01XM26E02
      Text in Illustration
      *1 Groove
      *2 Claw

      Align the claw of the starter brush holder with the groove of the starter yoke.

    2. Place the starter brush holder on the starter yoke.

    3. A01XKVA

      Connect the 4 brushes to the starter brush holder.


      1. Using a screwdriver, pull back the spring.

      2. Connect the brush to the brush holder.

        Note

        Make sure that the positive (+) lead wires are not grounded.

    4. Install a new O-ring to the starter yoke.

  4. INSTALL STARTER YOKE ASSEMBLY


    1. A01XELIE01
      Text in Illustration
      *1 Claw
      *2 Groove

      Align the claw of the starter brush holder with the groove of the magnet starter switch and install the starter yoke to the magnet starter switch.

    2. Install the starter yoke to the starter housing with the 2 bolts.

      Torque:
      14 N*m  { 145 kgf*cm, 10 ft.*lbf }

    3. Connect the lead wire to terminal C with the nut.

      Torque:
      24 N*m  { 245 kgf*cm, 18 ft.*lbf }