STARTER(for 2.7 kW Type) REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT NO. 1 FENDER APRON TO FRAME SEAL LH


    1. Remove the 5 clips and frame seal.

  3. REMOVE REAR ENGINE UNDER COVER ASSEMBLY

    Click here

  4. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

    Click here

  5. REMOVE STARTER ASSEMBLY


    1. Remove the terminal cap.

    2. B001G89

      Remove the nut and disconnect the starter wire.

    3. Disconnect the starter connector.

    4. B001E1T

      Remove the bolt, nut and starter assembly.