REPAIR INSTRUCTION INITIALIZATION


  1. PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL

    Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
    Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See page
    Correction of steering angle neutral point Calibration

    for Vehicle stability control system (for Hydraulic Brake Booster) Click here

    for Parking assist monitor system (w/ Side Monitor System) Click here

    for Parking assist monitor system (for Camera built-in ECU) Click here

    Note


    • After the battery is reconnected, be sure to wait 10 seconds or more before attempting to start the engine. The engine may not start immediately after the battery is reconnected.

    • w/ Navigation System:

      After the engine switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the engine switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

  2. PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

    Procedures Necessary when ECU or Other Parts are Replaced
    Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed See Page

      for 2TR-FE:

    • ECM

    		 Register VIN DTC P0630 is output

    Click here


      for 2TR-FE:

    • Throttle body with motor assembly

    • Cleaning the deposits from the throttle body with motor assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair Poor idle, engine starting, etc.

    Click here


      for 1GR-FE:

    • ECM

    		 Register VIN DTC P0630 is output

    Click here


      for 1GR-FE, Automatic Transmission:

    • Throttle body with motor assembly

    • Cleaning the deposits from the throttle body with motor assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair Poor idle, engine starting, etc.

    Click here


      for 1GR-FE, Manual Transmission:

    • ECM

    • Throttle body with motor assembly

    • Learning values save

    • Learning values write

    		 Engine starting

    Click here


      for 1KD-FTV:

    • ECM

    • Learning values save

    • Learning values write

    		 Engine starting

    Click here

    Register VIN DTC P0630 is output

      for 1KD-FTV:

    • Engine assembly

    • Clear crank time compensation data

    • Input injector compensation code

    • Pilot quantity learning

    		 Engine starting

    Click here (for Initialization)

    Click here (for Registration)

      for 1KD-FTV:

    • Crankshaft position sensor plate

    		 Clear crank time compensation data Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data

    Click here


      for 1KD-FTV:

    • Fuel supply pump

    		 Supply pump initialization Engine startability is affected

    Click here


      for 1KD-FTV:

    • Fuel injector

    • Injector compensation code registration

    • Pilot quantity learning

    		 Injector fuel injection compensation amount is same as before replacement, affecting injector fuel injection volume

    Click here


      for 1GD-FTV:

    • ECM

    • Learning values save

    • Learning values write

    		 Engine starting

    Click here

    Register VIN DTC P0630 is output

      for 1GD-FTV:

    • Engine assembly

    • Clear crank time compensation data

    • Input injector compensation code

    • Pilot quantity learning

    		 Engine starting

    Click here (for Initialization)

    Click here (for Registration)

      for 1GD-FTV:

    • Crankshaft position sensor plate

    		 Clear crank time compensation data Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data

    Click here


      for 1GD-FTV:

    • Air fuel ratio sensor

    		 Clear A/F sensor compensation data -

      for 1GD-FTV:

    • Exhaust manifold converter sub-assembly

    		 Clear DPF deterioration data -

      for 1GD-FTV:

    • Injector assembly

    • Input injector compensation code

    • Pilot quantity learning

    		 Engine starting

    Click here


      for 1GD-FTV, w/ Urea SCR System:

    • ECM

    • Learning values save

    • Learning values write

    		 Engine starting

    Click here

    Register VIN DTC P0630 is output

      for 1GD-FTV, w/ Urea SCR System:

    • Engine assembly

    • Clear crank time compensation data

    • Input injector compensation code

    • Pilot quantity learning

    		 Engine starting

    Click here (for Initialization)

    Click here (for Registration)

      for 1GD-FTV, w/ Urea SCR System:

    • Crankshaft position sensor plate

    		 Clear crank time compensation data Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data

    Click here


      for 1GD-FTV, w/ Urea SCR System:

    • Air fuel ratio sensor

    		 Clear A/F sensor compensation data -

      for 1GD-FTV, w/ Urea SCR System:

    • Exhaust manifold converter sub-assembly

    		 Clear DPF deterioration data -

      for 1GD-FTV, w/ Urea SCR System:

    • Injector assembly

    • Input injector compensation code

    • Pilot quantity learning

    		 Engine starting

    Click here


    • ECM

    • Driving support ECU

    		 Initialization Dynamic radar cruise control system

    Click here

    Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly (Dynamic radar cruise control system)

    • Dynamic radar cruise control system

    • Pre-crash safety system

    Click here


      for A750F, 1KD-FTV:

    • Automatic transmission assembly

    • Valve body assembly

    • Any of the shift solenoid valves

    		 Reset memory Large shift shock

    Click here


      for AC60F, 2TR-FE:

    • Automatic transmission assembly

    • Transmission valve body assembly

    • Any of the shift solenoid valves

    		 Reset memory

    • Large shift shock

    • Engine overruns

    Click here


      for AC60F, 2TR-FE:

    • Automatic transmission fluid

    		 ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly.

      for AC60F, 1GR-FE:

    • Automatic transmission assembly

    • Transmission valve body assembly

    • Any of the shift solenoid valves

    		 Reset memory

    • Large shift shock

    • Engine overruns

    Click here


      for AC60F, 1GR-FE:

    • Automatic transmission fluid

    		 ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly.

      for AC60F, 1GD-FTV:

    • Automatic transmission assembly

    • Transmission valve body assembly

    • Any of the shift solenoid valves

    		 Reset memory

    • Large shift shock

    • Engine overruns

    Click here


      for AC60F, 1GD-FTV:

    • Automatic transmission fluid

    		 ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly.
    Tire pressure warning ECU and receiver

    1. Register transmitter IDs

    2. Initialize tire pressure warning system

    • When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates

    • Tire pressure monitoring function

    Click here (for Registration)

    Click here (for Initialization)
    Suspension control ECU Registration Air suspension system

    Click here


    • Brake actuator assembly

    • Acceleration sensor

    		 Calibration Anti-lock brake system

    Click here


    • Master cylinder solenoid (Skid control ECU)

    • Yaw rate and acceleration sensor

    • Spiral cable sub-assembly (steering angle sensor)

    		 Calibration Vehicle stability control system (for Hydraulic Brake Booster)

    Click here


    • Brake actuator assembly (Skid control ECU)

    • Yaw rate and acceleration sensor

    • Spiral cable sub-assembly (steering angle sensor)

    		 Calibration Vehicle stability control system (for Vacuum Brake Booster)

    Click here

    Telematics transceiver Register vehicle information Emergency call service

    Click here

    Mobilephone battery Reset mobilephone battery condition

    • Spiral cable sub-assembly

    • Parking assist ECU

    • Rear television camera assembly

    		 Calibration Parking assist monitor system (w/ Side Monitor System)

    Click here


    • Spiral cable sub-assembly

    • Rear television camera assembly

    		 Calibration Parking assist monitor system (for Camera built-in ECU)

    Click here


    • Spiral cable sub-assembly

    • Parking assist ECU

    • Front passenger side television camera assembly

    • Driver side television camera assembly

    • Outer rear view mirror assembly

    		 Calibration Side monitor system

    Click here


      w/ Entry and Start System:

    • Steering lock actuator assembly

    • Certification ECU

    • ID code box

    • Key

    • ECM

    		 Code registration

    • Engine immobiliser system

    • Engine start

    • Steering lock and unlock

    • Entry and Start System (for Entry Function)

    • Wireless door lock control system

    		 Refer to the Service Bulletin for the registration procedure.

      w/o Entry and Start System:

    • Transponder key ECU

    • ECM

    • Key

    		 Code registration

    • Engine immobiliser system

    • Engine start

    		 Refer to the Service Bulletin for the registration procedure.

    • Door control receiver assembly

    • Key

    		 Code registration Wireless door lock control system (w/o Entry and Start System)

    Click here

    Fold seat control ECU Position memory initialization Rear power seat system

    Click here


    • Door window regulator assembly

    • Power window regulator motor assembly

    • Door glass

    • Door glass run

    		 Initialize power window control system

    • Auto up and down function

    • Remote control function

    • Key-linked function

    • Wireless transmitter-linked function

    • Key-off operation function

    • Jam protection function

    • Catch protection function

    Click here


    • Sliding roof ECU (sliding roof drive gear sub-assembly)

    • Sliding roof glass

    • Sliding roof housing

    		 Sliding roof system initialization

    • DTC B2343 output

    • AUTO operation

    • Jam protection function

    • Key-off operation

    • Wireless transmitter-linked operation function

    • Key-linked operation function

    Click here


    • Height control sensor

    • Headlight leveling ECU

    • Suspension

    		 Headlight leveling ECU initialization Headlight leveling function

    Click here