EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Note

    w/ Urea SCR System:

    Do not hold the front exhaust pipe assembly at the location shown in the illustration. Otherwise, it may become deformed or damaged, adversely affecting its thermal insulation capabilities.

    B001G4O

    1. B001EXO

      Using a vernier caliper, measure the free length of the compression spring.

      Minimum free length
      38.5 mm (1.52 in.)

      • If the free length is less than the minimum, replace the compression spring.

    2. B001ID4E27
      Text in Illustration
      *1 Gasket
      *a Wooden Block

      Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the front exhaust pipe assembly.

      Note


      • Be sure to install the gasket so that it faces the correct direction.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • When connecting the front exhaust pipe assembly, do not push in the gasket with the front exhaust pipe assembly.

    3. Install a new gasket and the front exhaust pipe assembly and 2 compression springs with the 2 bolts.

    4. B001HNFE01
      Text in Illustration
      *a Torque Wrench Fulcrum Length

      w/ Urea SCR System:

      Using a 14 mm union nut wrench, tighten the 2 bolts.

      Torque:
      Specified tightening torque
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

      • When using a union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 38N*m (385 kgf*cm, 28 ft.*lbf)

    5. w/o Urea SCR System:

      Install the front exhaust pipe assembly and 2 compression springs with the 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

    6. Connect the front exhaust pipe assembly to the exhaust pipe support.

  2. INSTALL UREA INJECTOR SET (w/ Urea SCR System)

    Click here

  3. INSTALL CENTER EXHAUST PIPE ASSEMBLY


    1. for 3 Door:

      Connect the center exhaust pipe assembly to the 2 exhaust pipe supports.

    2. for 5 Door:

      Connect the center exhaust pipe assembly to the 3 exhaust pipe supports.

    3. Install the center exhaust pipe assembly with the 2 bolts.

      Torque:
      48 N*m  { 489 kgf*cm, 35 ft.*lbf }

  4. INSTALL NO. 4 EXHAUST GAS TEMPERATURE SENSOR (w/ Urea SCR System)

    Click here

  5. INSTALL NITROGEN OXIDES SENSOR (w/ Urea SCR System)

    Click here

  6. INSTALL NO. 3 SENSOR BRACKET (w/ Urea SCR System)

    Click here

  7. INSTALL TAILPIPE ASSEMBLY


    1. Install a new gasket to the tailpipe assembly.

    2. Connect the tailpipe assembly to the exhaust pipe support.

    3. Connect the tailpipe to the center exhaust pipe assembly.

    4. Install the 2 bolts.

      Torque:
      48 N*m  { 489 kgf*cm, 35 ft.*lbf }

  8. INSPECT FOR EXHAUST GAS LEAK


    • If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.