FUEL INJECTOR REMOVAL

PROCEDURE


  1. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

    Click here

  5. DISCONNECT FUEL HOSE

    B001D4Q

    1. Disconnect the fuel hose Click here.

  6. DISCONNECT NO. 2 FUEL HOSE

    B001C95

    1. Slide the clamp and disconnect the No. 2 fuel hose.

  7. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

    Click here

  8. REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR

    B001DJR

    1. Disconnect the 4 fuel injector assembly connectors.

    2. Disconnect the purge VSV connector.

    3. Detach the wire harness clamp.

    4. Remove the bolt and disconnect the wire harness clamp bracket.

    5. B001G6A

      Remove the bolt and disconnect the purge VSV.

    6. B001CIG

      Remove the 2 bolts and fuel delivery pipe together with the fuel injectors.

      Note

      Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

    7. B001D5AE03
      Text in Illustration
      *a Protective Tape

      Remove the 2 No. 1 delivery pipe spacers.

    8. Remove the 4 injector vibration insulators.

    9. Using a screwdriver, remove the 4 spacers.

      Tech Tips

      Tape the screwdriver tip before use.

  9. REMOVE FUEL INJECTOR ASSEMBLY


    1. B001HY1

      Remove the 4 fuel injector assemblies from the fuel delivery pipe.

      Text in Illustration
      B001CHY Pull Out
    2. B001HYWE01
      Text in Illustration
      *a O-ring

      Remove the 4 O-rings from the 4 fuel injector assemblies.