FUEL PUMP(for Double Tank Type) INSTALLATION

PROCEDURE


  1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    1. Apply a light coat of diesel fuel or grease to a new gasket and install the gasket to the fuel tank sub-assembly.

    2. B001CZ8E10
      Text in Illustration
      *a Protrusion
      *b Groove

      Align the protrusion of the fuel suction with pump and gauge tube assembly with the groove of the fuel tank sub-assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.

    3. Install the fuel suction with pump and gauge tube assembly to the fuel tank sub-assembly.

    4. Put a new retainer on the fuel tank sub-assembly. While holding the fuel suction with pump and gauge tube assembly, tighten the retainer one complete turn by hand.

      Tech Tips

      Make sure the start marks on the retainer and fuel tank sub-assembly are aligned and then tighten the retainer.

      B001FLXE08
    5. B001DJLE01
      Text in Illustration
      *a Start Mark (Fuel Tank Side)
      *b Start Mark (Retainer Side)

      Set SST on the retainer.

      SST
      09808-14030

      Tech Tips


      • Hold the fuel suction with pump and gauge tube assembly upright by hand to ensure that the gasket is not moved out of position.

      • Engage the claws of SST securely with the retainer holes to secure SST.

      • Install SST while pressing the claws of SST against the retainer (toward the center of SST).

    6. B001CGGE08
      Text in Illustration
      *a Fuel Tank Side Mark
      *b Retainer Side Mark

      Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank sub-assembly as shown in the illustration.

      SST
      09808-14030

      Tech Tips

      Fit the tips of SST onto the ribs of the retainer.

  2. INSTALL FUEL TANK SUB-ASSEMBLY

    Click here