STARTER REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    1. Remove the exhaust manifold sub-assembly LH Click here.

  3. REMOVE STARTER COVER


    1. B001E5J

      Remove the 3 bolts and starter cover.

  4. REMOVE STARTER ASSEMBLY


    1. B001CV1

      Remove the bolt and disconnect the ground wire.

    2. Disconnect the starter connector.

    3. Open the terminal cap.

    4. Remove the nut and bolt, and then disconnect the starter wire.

    5. B001DT1

      Remove the 2 bolts and starter assembly.

  5. REMOVE FLYWHEEL HOUSING SIDE COVER

    B001CP0