FRONT BUMPER INSTALLATION


  1. INSTALL FRONT BUMPER ASSEMBLY


    1. A01I3NZ

      Move the front bumper assembly into position as shown in the illustration.

    2. Pull back the side of the front bumper assembly and connect the 2 front turn signal light connectors.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

    3. w/ Intuitive Parking Assist System:


      1. Pull back the side of the front bumper assembly and connect the 2 No. 1 ultrasonic sensor connectors.

        Note

        Do not apply excessive force when pulling back the front bumper assembly.

    4. Install the 2 bolts.

    5. Install the 2 hood center cushions and clip.

    6. A01I2VX

      Engage the 3 claws to install the front bumper assembly as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A01I3DSE01
      Text in Illustration
      *1 Pin Hold Clip
      *a Correct
      *b Incorrect

      Install the pin hold clip as shown in the illustration.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. Install the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    9. Install the 6 screws.

  2. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 9 clips.