VEHICLE PROXIMITY NOTIFICATION SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Turn the power switch off.

    2. Connect the Techstream to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the Techstream on.

    5. Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Data List.

    6. Read the Data List according to the display on the Techstream.

      Vehicle Proximity Notification System
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Shift Position P position switch / Not Parking or Parking Not Parking or Parking -
      Stop Light SW Stop light switch / OFF or ON

      OFF: Brake pedal released

      ON: Brake pedal depressed

      		 -
      Oil Pressure SW Oil pressure switch / OFF or ON

      OFF: Engine started

      ON: Engine not started

      		 -
      Vehicle Speed Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
      Proximity Sound Volume Adjustment Warning sound volume setting / Standard, Standard +1, Standard +2 Customized value displayed -
      Proximity Sound Level Increase (Vehicle Starting) Warning sound amplifier function when vehicle starts off / OFF or ON Customized value displayed -
      Proximity Sound Control (Vehicle Stationary) Warning sound setting function when vehicle stopped / OFF or ON Customized value displayed -
      Number of DTC Number of trouble codes / Min.: 0 Max.: 255 Number of DTCs displayed -

  2. ACTIVE TEST

    Tech Tips

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Turn the power switch off.

    2. Connect the Techstream to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the Techstream on.

    5. Enter the following menus: Body Electrical / Vehicle Proximity Notification System / Active Test.

    6. Perform the Active Test according to the display on the Techstream.

      Vehicle Proximity Notification System
      Tester Display Test Part Control Range Diagnostic Note
      Proximity Sound (Vehicle Stationary) Proximity sound (Vehicle stationary) OFF or ON Produces warning sound when vehicle is stopped
      Proximity Sound (Low Speed) Proximity sound (Low speed) OFF or ON Produces warning sound when vehicle is being driven at speeds of 10 km/h (6 mph)