AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM, Diagnostic DTC:B241A

DTC Code DTC Name
B241A Rear Height Control Sensor

DESCRIPTION

The headlight leveling ECU assembly receives signals indicating the height of the vehicle from the rear height control sensor sub-assembly.

DTC No. DTC Detecting Condition Trouble Area
B241A

  • Malfunction in rear height control sensor sub-assembly

  • Open or short in rear height control sensor sub-assembly circuit

  • Rear height control sensor sub-assembly

  • Harness or connector

  • Headlight leveling ECU assembly

WIRING DIAGRAM

A01I5GDE02

INSPECTION PROCEDURE

Note

If either of the following is performed, initialization of the headlight leveling ECU assembly is necessary Click here.


  • Replacement of the headlight leveling ECU assembly.

  • Replacement or removal/installation of the rear height control sensor sub-assembly or work that changes the vehicle height such as replacement of suspension components.

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC B241A is not output.

    NG

    READ VALUE USING TECHSTREAM Click here

    OK

    USE SIMULATION METHOD TO CHECK Click here

  2. READ VALUE USING TECHSTREAM


    1. Connect the Techstream to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the Techstream on.

    4. Enter the following menus: Body Electrical / HL Auto Leveling / Data List.

    5. Read the display on the Techstream.

      HL Auto Leveling
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Height Sens Pw Supply Val Rear height control sensor power supply value / 0.00 to 5.00 V Approx. 5 V -
      Rr Height Sens Signal Val Rear height control sensor signal value / 0.00 to 5.00 V Approx. 2.5 V (When the vehicle is level) Value changes according to vehicle height
      OK
      Normal conditions listed above are displayed.

    NG

    INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY Click here

    OK

    REPLACE HEADLIGHT LEVELING ECU ASSEMBLY Click here

  3. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. Remove the rear height control sensor sub-assembly Click here.

    2. Inspect the rear height control sensor sub-assembly Click here.


    NG

    REPLACE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY Click here

    OK

  4. CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - REAR HEIGHT CONTROL SENSOR)


    1. Disconnect the A34 headlight leveling ECU assembly connector.

    2. Disconnect the O17 rear height control sensor sub-assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A34-19 (SHRL) - O17-2 (SHRR) Always Below 1 Ω
      A34-19 (SHRL) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE HEADLIGHT LEVELING ECU ASSEMBLY Click here