HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


    1. Pass the hood lock control cable assembly into the engine compartment.

    2. Pass the hood lock control cable assembly through the upper radiator support.

    3. Engage the hood cable grommet.

    4. Engage the 5 clamps and install the hood lock control cable assembly.

  2. INSTALL HOOD LOCK ASSEMBLY


    1. A01I3Y3

      Apply MP grease to the sliding areas of the hood lock assembly.

    2. Connect the hood lock control cable assembly.

    3. Install the hood lock assembly with the 2 bolts and hood lock bolt.

      Torque:
      Bolt
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
      Hood Lock Bolt
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. w/ Engine Hood Courtesy Switch:


      1. Connect the connector.

    5. Install a new hood lock nut cap.

  3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.

  4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.

  5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    1. A01I4EE

      Insert the 2 clips in the direction indicated by the arrows shown in the illustration to engage them.

    2. Install the cowl side trim sub-assembly LH with the clip.

  6. INSTALL FRONT DOOR SCUFF PLATE LH


    1. Engage the 10 claws to install the front door scuff plate LH.

  7. INSTALL FRONT FENDER LINER LH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  8. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  9. INSTALL FRONT WHEEL LH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }

  10. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  11. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 9 clips.

  12. ADJUST HOOD SUB-ASSEMBLY

    Click here