HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01I34Z

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  3. REMOVE FRONT WHEEL LH

  4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  5. REMOVE FRONT FENDER LINER LH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  6. REMOVE FRONT DOOR SCUFF PLATE LH


    1. A01I29Q

      Disengage the 10 claws and remove the front door scuff plate LH.

  7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    1. A01I3JL

      Remove the clip.

    2. Pull the cowl side trim sub-assembly LH in the direction indicated by the arrow shown in the illustration to disengage the 2 clips and remove the cowl side trim sub-assembly LH.

  8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01I3QN

      Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.

  9. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01I3AP

      Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.

  10. REMOVE HOOD LOCK ASSEMBLY


    1. A01I5NGE01
      Text in Illustration
      *a Protective Tape

      Using a screwdriver, remove the hood lock nut cap.

      Tech Tips

      Tape the screwdriver tip before use.

    2. w/ Engine Hood Courtesy Switch:


      1. A01I28M

        Disconnect the connector.

    3. A01I4YPE01
      Text in Illustration
      *1 Hood Lock Bolt

      Remove the 2 bolts and hood lock bolt.

    4. A01I362

      Disconnect the hood lock control cable assembly and remove the hood lock assembly.

  11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. Using a screwdriver, disengage 5 clamps and hood cable grommet as shown in the illustration.

      A01I5PSE01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Hood Cable Grommet
      *3 Washer Hose *4 Hood Lock Control Cable Clamp

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull the hood lock control cable assembly from the engine compartment and remove it.