WIRELESS CHARGING SYSTEM Main Switch Power Source Circuit

DESCRIPTION

This circuit supplies power to the mobile wireless charger switch and illuminates the switch indicator light when the mobile wireless charger switch is turned on.

WIRING DIAGRAM

A01I51EE05

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (UPPER CONSOLE PANEL SUB-ASSEMBLY POWER SOURCE)


    1. Disconnect the I179 upper console panel sub-assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I179-4 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I179-2 (ACC) - I179-4 (GND1) Power switch on (ACC) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01I577E04
      Text in Illustration
      *a

      Component without harness connected

      (Upper Console Panel Sub-assembly)

      Disconnect the I179 and A upper console panel sub-assembly connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I179-2 (ACC) - A-11 (ACC) Always Below 1 Ω
      I179-4 (GND1) - A-12 (GND1) Always Below 1 Ω

    NG

    REPLACE UPPER CONSOLE PANEL SUB-ASSEMBLY Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here