WIRELESS CHARGING SYSTEM Wireless Charger Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the upper console panel sub-assembly.

WIRING DIAGRAM

A01I4LPE04

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (UPPER CONSOLE PANEL SUB-ASSEMBLY POWER SOURCE)


    1. Disconnect the I179 upper console panel sub-assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      I179-5 (PGND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I179-1 (ACC) - I179-5 (PGND) Power switch on (ACC) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here