FRONT SEAT OUTER BELT ASSEMBLY REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    1. A01I3Q8

      Disengage the claw to remove the luggage trim service hole cover.

  3. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR SCUFF PLATE


    1. A01I29Q

      Disengage the 10 claws and remove the front door scuff plate LH.

  5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  6. REMOVE REAR DOOR SCUFF PLATE


    1. A01I3SV

      Disengage the 6 claws and remove the rear door scuff plate LH.

      Tech Tips

      Disengage the claws from the rear side of the scuff plate.

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  8. REMOVE LAP BELT OUTER ANCHOR COVER


    1. A01I2SN

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A01I5ER

      Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.

  10. REMOVE CENTER PILLAR LOWER GARNISH


    1. A01I44B

      Disengage the 2 claws and 3 clips, and remove the center pillar lower garnish LH.

  11. REMOVE CENTER PILLAR UPPER GARNISH


    1. A01I3S7

      Remove the 2 screws.

    2. Disengage the clip.

    3. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH and remove the center pillar upper garnish LH.

  12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A01I5KD

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A01I4YOE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01I34B

      Remove the 2 bolts and front seat outer belt assembly.

  13. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A01I5PN

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.