FRONT SEAT ASSEMBLY (for Power Seat) INSTALLATION

INSTALL FRONT SEAT ASSEMBLY
1. Place the front seat assembly in the cabin.
  
  Note
  
  Be careful not to damage the vehicle body.
2. Connect each connector and clamp under the seat.
3. Connect the cable to the negative (-) auxiliary battery terminal.
  
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
4. Temporarily install the front seat assembly with the 4 bolts.
5. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.
6. Tighten the 2 bolts on the front side of the seat.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
  
  Note
  
  Tighten the bolts in the order indicated in the illustration.
7. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.
8. Tighten the 2 bolts on the rear side of the seat.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
  
  Note
  
  Tighten the bolts in the order indicated in the illustration.
INSTALL REAR INNER SEAT TRACK BRACKET COVER
1. Engage the 2 claws to install the rear inner seat track bracket cover.
INSTALL REAR OUTER SEAT TRACK BRACKET COVER
1. Engage the 2 claws to install the rear outer seat track bracket cover.
INSTALL FRONT SEAT HEADREST ASSEMBLY
INSTALL LUGGAGE TRIM SERVICE HOLE COVER
1. Engage the claw to connect the luggage trim service hole cover.
PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Side)

Click here
INSPECT FRONT SEAT ASSEMBLY
1. Check the power seat operation Click here.
2. w/ Seat Heater System:
  
  Check the seat heater operation.
  1. Turn the power switch on (IG).
  2. Turn the seat heater switch on.
  3. Wait 5 minutes or more and confirm that the seat surface becomes warm.
INSPECT SRS WARNING LIGHT

Click here