FRONT SEAT ASSEMBLY (for Manual Seat) INSTALLATION

INSTALL FRONT SEAT ASSEMBLY
1. Place the front seat assembly in the cabin.
  
  Note
  
  Be careful not to damage the vehicle body.
2. Connect each connector and clamp under the front seat assembly.
3. Temporarily install the front seat assembly with the 4 bolts.
4. Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.
5. Tighten the 2 bolts on the front side of the front seat assembly.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
  
  Note
  
  Tighten the bolts in the order indicated in the illustration.
6. Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.
7. Tighten the 2 bolts on the rear side of the front seat assembly.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
  
  Note
  
  Tighten the bolts in the order indicated in the illustration.
INSPECT SEAT SLIDE ADJUSTER LOCKS
1. During the sliding operation of the front seat assembly, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.
INSTALL REAR INNER SEAT TRACK BRACKET COVER
1. Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.
2. Engage the 2 claws to install the rear inner seat track bracket cover.
INSTALL REAR OUTER SEAT TRACK BRACKET COVER
1. Engage the 2 claws to install the rear outer seat track bracket cover.
INSTALL FRONT SEAT HEADREST ASSEMBLY
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL LUGGAGE TRIM SERVICE HOLE COVER
1. Engage the claw to connect the luggage trim service hole cover.
PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK

Click here
INSPECT SRS WARNING LIGHT

Click here