LIGHTING SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the lighting system.

  • *: Use the Techstream.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK


    NEXT

  3. INSPECT AUXILIARY BATTERY VOLTAGE


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


      NEXT

  4. INSPECT CAN COMMUNICATION SYSTEM*


    1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN communication system DTC is not output. A
      CAN communication system DTC is output. B

      B

      GO TO CAN COMMUNICATION SYSTEM
      A

  5. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed in Problem Symptoms Table. A
    Fault is listed in Problem Symptoms Table. B

    B

    Go to step 7
    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test Click here

    2. Terminals of ECU Click here


      NEXT

  7. ADJUST, REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END