DOOR CONTROL RECEIVER INSTALLATION


  1. INSTALL DOOR CONTROL RECEIVER (w/o Tire Pressure Warning System)


    1. Install the door control receiver with the bolt.

    2. Connect the connector.

  2. INSTALL DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY (w/ Tire Pressure Warning System)


    1. Install the door control and tire pressure monitoring system receiver assembly with the bolt.

    2. Connect the connector.

  3. INSTALL ROOF SIDE INNER GARNISH RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH


    1. A01I3CBE01
      Text in Illustration
      *1 Alignment Mark (Blue)

      Align the alignment mark (Blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip RH.

      Note

      After installation, check that the corners fit correctly.

  5. INSTALL REAR SIDE SEATBACK ASSEMBLY RH


    1. Engage the hook to install the rear side seatback assembly RH.

    2. Install the 2 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    3. Connect the connector.

    4. Connect the rear seat outer belt to the rear seat shoulder belt guide RH.

  6. INSTALL REAR SEAT CUSHION LOCK HOOK


    1. A01I58V

      Engage the claw to install a new rear seat cushion lock hook.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  7. INSTALL REAR SEAT CUSHION ASSEMBLY


    1. Place the rear seat cushion assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. A01I5UX

      Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.

  8. CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL LUGGAGE TRIM SERVICE HOLE COVER


    1. Engage the claw to connect the luggage trim service hole cover.

  10. REGISTER TRANSMITTER ID (w/ Tire Pressure Warning System)

    Click here

  11. INSPECT TIRE PRESSURE WARNING SYSTEM (w/ Tire Pressure Warning System)

    Click here

  12. INSPECT SRS WARNING LIGHT

    Click here