NAVIGATION SYSTEM Reverse Signal Circuit

DESCRIPTION

The navigation receiver assembly receives a reverse signal from the No. 1 integration relay.

WIRING DIAGRAM

A01I5YAE17

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK BACK-UP LIGHT


    1. Check that the back-up light comes on.

      OK
      The back-up light comes on.

    NG

    GO TO LIGHTING SYSTEM Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)


    1. Disconnect the I74 navigation receiver assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      I74-2 (REV) - Body ground

      Power switch on (IG)

      Shift lever in R

      		 11 to 14 V
      I74-2 (REV) - Body ground

      Power switch on (IG)

      Shift lever not in R

      		 Below 1 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here