FRONT DOOR SPEAKER REMOVAL

Note


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. A01I2AZ

      Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel plug as shown in the illustration.

  2. REMOVE FRONT DOOR FRONT LOWER FRAME UPPER COVER


    1. A01I5CZ

      Disengage the 2 claws and 2 guides and remove the front door front lower frame upper cover.

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. A01I4U8

      Using a moulding remover, disengage the 2 clips, 6 claws and 3 guides as shown in the illustration.

    2. Disconnect each connector and remove the power window regulator master switch assembly with front door armrest base panel.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. A01I5HC

      Using a moulding remover, disengage the 2 clips, 6 claws and 3 guides as shown in the illustration.

    2. Disconnect each connector and remove the power window regulator switch assembly with front door armrest base panel.

  5. REMOVE FRONT ARMREST ASSEMBLY


    1. A01I4QB

      Using a moulding remover, disengage the 3 clips, 7 claws and 2 guides and remove the front armrest assembly.

  6. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01I56WE01
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw.

    2. Disconnect the connector and remove the courtesy light assembly.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01I3H7E02
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the front door panel.

    2. A01I5OQ

      Remove the 3 screws.

    3. Using a clip remover, disengage the 10 clips.

    4. A01I312E02
      Text in Illustration
      *1 Front Door Inner Glass Weatherstrip
      *a Reference Boss

      Pull out the front door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.

    5. Disengage the reference boss from the front door panel.

    6. Raise the front door trim board sub-assembly to remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.

    7. A01I5RN

      Disengage the clamp.

    8. Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.

  8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP


    1. A01I3ICE02
      Text in Illustration
      *a Screwdriver

      Using a screwdriver, disengage the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.

  9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

    Note

    Do not touch the speaker cone.


    1. A01I631

      Disconnect the connector.

    2. Remove the 4 screws.

    3. A01I5H9

      Disengage the 2 claws and remove the front No. 1 speaker assembly.