VSC OFF SWITCH REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Click here

  3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    1. A01I56B

      Disconnect the front door opening trim weatherstrip LH.

  4. REMOVE INSTRUMENT SIDE PANEL LH


    1. A01I3Y0

      Using a moulding remover, disengage the 4 claws as shown in the illustration.

    2. A01I58G

      Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.

  5. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. A01I3EV

      Disengage the 3 clips to remove the No. 1 instrument cluster finish panel garnish as shown in the illustration.

  6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01I5MJE01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. A01I43K

      Disengage the 2 clips as shown in the illustration.

    3. A01I4H5

      Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.

  7. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.

    2. A01I476

      Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.

    3. A01I5RJ

      Disengage the 5 claws, 5 clips and 2 guides.

    4. Disconnect each connector.

    5. A01I5IR

      Remove the instrument cluster finish panel assembly as shown in the illustration.

  8. REMOVE VSC OFF SWITCH


    1. A01I3XB

      Disengage the 2 claws and remove the VSC OFF switch from the instrument cluster finish panel assembly.