BATTERY COOLING DUCT (w/ Filter) INSTALLATION


  1. INSTALL NO. 1 HYBRID BATTERY INTAKE FILTER


    1. A01I2TC

      Install the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

      Note

      Make sure the rubber portion of the No. 1 hybrid battery intake filter is behind the points shown in the illustration.

      A01I30ME01
      Text in Illustration
      *a Cross Section View of No. 1 Hybrid Battery Intake Duct
      *b Rubber Portion of No. 1 Hybrid Battery Intake Filter
    2. A01I31OE02
      Text in Illustration
      *a Tape

      Apply 3 pieces of tape as shown in the illustration to secure the No. 1 hybrid battery intake filter to the No. 1 hybrid battery intake duct.

      Tech Tips

      If the adhesion of the tape is weak, replace it with new tape.

  2. INSTALL REAR SIDE SEATBACK ASSEMBLY LH


    1. Engage the hook to install the rear side seatback assembly LH.

    2. Install the 2 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    3. Connect the connector.

    4. Connect the rear seat outer belt to the rear seat shoulder belt guide LH.

  3. INSTALL REAR SEATBACK ASSEMBLY


    1. Lift the rear seat back assembly LH.

    2. A01I3WS

      Engage the guide and claw to install the No. 2 room partition cover.

    3. Connect the rear seat outer belt to the rear seat center shoulder belt guide.

    4. Lift the rear seat back assembly RH.

  4. INSTALL REAR SEAT CUSHION LOCK HOOK


    1. A01I58V

      Engage the claw to install a new rear seat cushion lock hook.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  5. INSTALL REAR SEAT CUSHION ASSEMBLY


    1. Place the rear seat cushion assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. A01I5UX

      Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.

    3. Confirm that the seat cushion is firmly installed.

      Note

      When installing the seat cushion, make sure that the seat belt buckles are not under the seat cushion.

  6. CLEAR DTC

    Tech Tips

    If the message "Maintenance Required for Hybrid Battery Cooling Parts at Your Dealer" is displayed on the multi-information display in the combination meter assembly, clean or replace the No. 1 hybrid battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output Click here.