SUB RADIATOR REMOVAL


  1. DRAIN COOLANT (for Inverter)

    Note


    • Do not reuse the drained coolant because it may contain foreign objects.

    • Collect the drained coolant and measure its volume to establish a benchmark. When adding coolant, make sure to add more coolant than the measured amount.


    1. Remove the reserve tank cap.

      CAUTION:

      To avoid the danger of being burned, do not remove the reserve tank cap while the coolant for the inverter is still hot.

    2. A01I4EO

      Using a hexagon wrench (10 mm), remove the drain plug indicated in the illustration and drain the coolant.

      CAUTION:

      Use caution when handling coolant immediately after driving or in summer because it may be hot.

    3. Install the plug with a new gasket.

      Torque:
      39 N*m  { 397 kgf*cm, 29 ft.*lbf }

  2. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  3. REMOVE FRONT BUMPER ENERGY ABSORBER


    1. A01I5GZ

      Disengage the 2 guides and remove the front bumper energy absorber.

  4. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    1. A01I5GZ

      Disengage the 2 guides and remove the front bumper energy absorber.

  5. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01I41G

      Remove the 2 bolts and inlet air cleaner assembly.

  6. REMOVE NO. 5 INVERTER BRACKET


    1. A01I3ST

      Remove the 2 bolts and No. 5 inverter bracket.

  7. REMOVE RADIATOR RESERVE TANK ASSEMBLY


    1. A01I2VZ

      Disconnect the radiator reserve tank hose.

    2. Remove the 2 bolts and radiator reserve tank assembly.

  8. REMOVE HOOD LOCK ASSEMBLY


    1. A01I5NGE01
      Text in Illustration
      *a Protective Tape

      Using a screwdriver, remove the hood lock nut cap.

      Tech Tips

      Tape the screwdriver tip before use.

    2. w/ Engine Hood Courtesy Switch:


      1. A01I28M

        Disconnect the connector.

    3. A01I4YPE01
      Text in Illustration
      *1 Hood Lock Bolt

      Remove the 2 bolts and hood lock bolt.

    4. A01I362

      Disconnect the hood lock control cable assembly and remove the hood lock assembly.

  9. REMOVE UPPER RADIATOR SUPPORT


    1. A01I4YB

      Disconnect the 2 connectors.

    2. A01I5OO

      Disconnect the hood lock control cable clamp and remove the 5 bolts and upper radiator support.

    3. Remove the 2 radiator support cushions.

  10. REMOVE RADIATOR SIDE DEFLECTOR RH


    1. A01I474

      Disengage the 3 claws and remove the radiator side deflector RH.

  11. REMOVE RADIATOR ASSEMBLY


    1. A01I66H

      Disconnect the 2 water hoses.

      Note

      Put pieces of cloth into the pipes and in the disconnected hoses or cover the pipes and hoses with plastic bags to prevent entry of foreign matter.

    2. A01I41F

      Remove the 4 bolts and radiator assembly.