HYBRID CONTROL SYSTEM, Diagnostic DTC:P0A37-260, P0A3A-258

DTC Code DTC Name
P0A37-260 Generator Temperature Sensor Circuit Range / Performance
P0A3A-258 Generator Temperature Sensor Circuit Intermittent

DESCRIPTION

The resistance of the thermistor built into the generator temperature sensor changes in accordance with changes in generator (MG1) temperature. The lower the generator (MG1) temperature, the higher the thermistor resistance. Conversely, the higher the generator (MG1) temperature, the lower the resistance.

A01I2URE06
DTC No. INF Code DTC Detection Condition Trouble Area
P0A37 260

Generator temperature sensor output does not increase in which the value should increase, or output does not decrease under conditions in which the value should decrease.

(1 trip detection logic)

 Hybrid vehicle transaxle assembly (Generator temperature sensor)
P0A3A 258

Sudden change in generator temperature sensor output or hunting:

Unusual sudden change in generator temperature sensor output occurs and offset condition continues for a certain period of time, or unusual change in motor temperature sensor output occurs repeatedly.

(1 trip detection logic)
Related Data List
DTC No. Data List
P0A37-260 Motor Temp No2
P0A3A-258

INSPECTION PROCEDURE

Tech Tips


  • If DTC P0A37-260 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.


    1. Drive the vehicle (stop and go driving) on urban roads for approximately 5 minutes. If the Data List item "Motor Temp No2" shows both increases and decreases in temperature, suspected areas indicated by this DTC are not malfunctioning.

  • If DTC P0A3A-258 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.


    1. Turn the power switch on (READY) and wait for 30 seconds or more.

    2. Drive the vehicle for approximately 5 minutes according to the freeze frame data items "Vehicle Spd", "Inverter Coolant Water Temperature", "Motor Temp No1" and "Motor Temp No2".

PROCEDURE


  1. REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here (When Not Using the Engine Support Bridge))

    Click here (When Using the Engine Support Bridge))

    Tech Tips

    The generator temperature sensor is not available separately. If it requires replacement, replace the hybrid vehicle transaxle assembly.


    NEXT

    COMPLETED