CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01I4EV

      Lift the rear of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the No. 1 engine cover sub-assembly from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear pins at the same time may cause the No. 1 engine cover sub-assembly to break.

  2. REMOVE CAMSHAFT POSITION SENSOR


    1. A01I54L

      Disconnect the sensor connector.

    2. Remove the bolt and sensor.