ECM REMOVAL


  1. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    1. A01I3Q8

      Disengage the claw to remove the luggage trim service hole cover.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ECM


    1. A01I351

      Disconnect the 2 ECM connectors.


      1. Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

    2. A01I3WWE01

      Remove the nut.

    3. Remove the screw (A).

    4. Loosen the screw (B) and remove the ECM.

    5. Remove the screw (B).

    6. A01I29B

      Remove the 2 screws and No. 2 ECM bracket.

  4. REMOVE NO. 1 RELAY BLOCK COVER

  5. REMOVE NO. 1 ECM BRACKET


    1. A01I63H

      Remove the nut.

    2. Release the 2 clamps and disconnect the wire harness.

    3. A01I67S

      Disconnect the wire harness clamp.

    4. A01I5Z2

      Remove the nut and No. 1 ECM bracket.