FRONT BUMPER REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01HXU2

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. A01HXTC

      Apply protective tape around the front bumper assembly as shown in the illustration.

      Text in Illustration
      A01I1AA Protective Tape
    2. A01HYR1

      Remove the 7 screws.

    3. A01HZLUE01
      Text in Illustration
      *1 Pin Hold Clip
      *a 90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. A01HYYD

      Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws as shown in the illustration.

      Text in Illustration
      A01I1AA Protective Tape

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. w/ Intuitive Parking Assist System:


      1. Pull back the side of the front bumper assembly and disconnect the 2 No. 1 ultrasonic sensor connectors.

        Note

        Do not apply excessive force when pulling back the front bumper assembly.

    7. Pull back the side of the front bumper assembly and disconnect the 2 front turn signal light connectors.

      Note

      Do not apply excessive force when separating the front bumper assembly.

    8. A01I02K

      Using a clip remover, remove the clip and 2 hood center cushions.

    9. A01HZ4I

      Remove the 2 bolts.

    10. A01HYTQ

      Remove the front bumper assembly as shown in the illustration.