OUTER REAR VIEW MIRROR INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


    1. Engage the clip and claw to temporarily install the outer rear view mirror assembly.

    2. Install the 3 bolts.

      Torque:
      11 N*m  { 107 kgf*cm, 8 ft.*lbf }

    3. Install the outer rear view mirror assembly with the clip.

    4. Connect the connector.

  2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP


    1. A01I0AY

      Install the front door inner glass weatherstrip.

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01HY0RE01
      Text in Illustration
      *1 Front Door Inside Locking Cable Assembly
      *2 Front Door Lock Remote Control Cable Assembly

      Connect the front door lock remote control cable assembly and front door inside locking cable assembly.

    2. Engage the clamp.

    3. A01I0KKE01
      Text in Illustration
      *a Reference Boss

      Engage the 4 claws and reference boss as shown in the illustration.

    4. A01I1QO

      Engage the 10 clips to install the front door trim board sub-assembly.

    5. Install the 3 screws.

    6. Remove protective tape.

  4. INSTALL COURTESY LIGHT ASSEMBLY


    1. Connect the connector.

    2. A01HXJXE01
      Text in Illustration
      *A for LH Side
      *B for RH Side

      Engage the claw to install the courtesy light assembly.

  5. INSTALL FRONT ARMREST ASSEMBLY


    1. A01I1BN

      Engage the 2 guides, 3 clips and 7 claws to install the front armrest assembly.

  6. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. Connect each connector.

    2. A01HXWG

      Engage the 3 guides, 2 clips and 6 claws to install the power window regulator master switch assembly with front door armrest base panel.

  7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. Connect each connector.

    2. A01I0T0

      Engage the 3 guides, 2 clips and 6 claws to install the power window regulator switch assembly with front door armrest base panel.

  8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


    1. A01I0MZ

      Engage the 3 clips to install the front door lower frame bracket garnish.

  9. INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER


    1. A01I1XM

      Engage the 2 guides and 2 claws to install the front door front lower frame upper cover.

  10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. A01I09B

      Engage the 3 claws to install the front door inside handle bezel plug.