LUGGAGE COMPARTMENT DOOR ADJUSTMENT


  1. REMOVE LUGGAGE COMPARTMENT DOOR COVER


    1. A01HYJE

      Remove the 13 clips and luggage compartment door cover.

  2. REMOVE SPARE WHEEL COVER ASSEMBLY


    1. Remove the spare wheel cover assembly.

  3. REMOVE REAR FLOOR FINISH PLATE


    1. A01I1K5

      Remove the 5 clips.

    2. A01HZHR

      Disengage the 4 clips and remove the rear floor finish plate.

  4. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH


    1. A01I0N8

      Remove the 2 clips.

    2. Disengage the clip and remove the luggage compartment door hinge cover LH.

  5. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. ADJUST LUGGAGE COMPARTMENT DOOR


    1. A01I0BD

      Loosen the door side hinge bolts to adjust the door horizontally and vertically.

      Torque:
      7.5 N*m  { 77 kgf*cm, 66 in.*lbf }
    2. A01HZ8O

      Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.

    3. Using a brass bar and a hammer, hit the striker to adjust its position.

    4. Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

      Torque:
      23 N*m  { 235 kgf*cm, 17 ft.*lbf }

  7. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH


    1. A01I0N8

      Engage the clip.

    2. Install the luggage compartment door hinge cover LH with the 2 clips.

  8. INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  9. INSTALL REAR FLOOR FINISH PLATE


    1. A01HYH0

      Engage the 4 clips to install the rear floor finish plate.

    2. Install the 5 clips.

  10. INSTALL SPARE WHEEL COVER ASSEMBLY


    1. Install the spare wheel cover assembly.

  11. INSTALL LUGGAGE COMPARTMENT DOOR COVER


    1. A01HYJE

      Install the luggage compartment door cover with the 13 clips.

  12. INSPECT LUGGAGE COMPARTMENT DOOR


    1. Check that the clearance measurements of areas a through d are within each standard range.

      A01HXW9E01
      Standard Clearance
      Area Measurement Area Measurement
      a 6.15 mm (0.242 in.) b 2.0 to 5.0 mm (0.0787 to 0.197 in.)
      c -1.2 to 1.8 mm (-0.0472 to 0.0709 in.) d 6.05 mm (0.238 in.)