OUTER REAR VIEW MIRROR COVER (w/o Side Turn Signal Light) REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. REMOVE OUTER MIRROR (for TMMK Made)


    1. A01I08KE02
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the lower part of the mirror surface and tilt it.

    3. A01HXVVE02
      Text in Illustration
      *a Moulding Remover

      Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.

    4. A01I0UL

      Disengage the 2 guides and remove the outer mirror as shown in the illustration.

    5. w/o Blind Spot Monitor System:


      1. A01I0TA

        Disconnect the 2 connectors and remove the outer mirror.

    6. w/ Blind Spot Monitor System:


      1. Disconnect the 2 mirror heater connectors.

      2. Disengage the 2 claws.

      3. A01HZVLE02
        Text in Illustration
        *a Mirror Heater Connector
        *b Blind Spot Monitor Indicator Connector

        Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror with a new one.

  2. REMOVE OUTER MIRROR (for SIA Made)


    1. A01HZI4E01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.

    4. A01I0NGE01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    5. Push the lower part of the mirror surface and tilt it.

    6. Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.

    7. A01HZPO

      Disconnect the 2 connectors and remove the outer mirror.

  3. REMOVE OUTER MIRROR COVER (for TMMK Made)


    1. A01I0RB

      Disengage the 8 claws and remove the outer mirror cover.

  4. REMOVE OUTER MIRROR COVER (for SIA Made)


    1. A01HZLI

      Remove the 3 screws.

    2. A01I1OG

      Disengage the clamp.

    3. Disconnect the connector and remove the mirror actuator.

    4. A01I1SO

      Disengage the 8 claws and remove the outer mirror cover.