WIRELESS CHARGER MAIN SWITCH INSPECTION


  1. INSPECT MOBILE WIRELESS CHARGER SWITCH


    1. A01HYKJE06
      Text in Illustration
      *a

      Component without harness connected

      (Mobile Wireless Charger Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      11 (ACC) - 8 (SW) Mobile wireless charger switch is on (not protruding) Below 1 Ω
      Mobile wireless charger switch is off (protruding) 10 kΩ or higher

      If the result is not as specified, replace the mobile wireless charger switch.

    2. Check that the switch indicator light illuminates.


      1. A01HYKJE07
        Text in Illustration
        *a

        Component without harness connected

        (Mobile Wireless Charger Switch)

        Apply battery voltage to the mobile wireless charger switch connector and check the operation of the switch indicator light.

        OK
        Connection Condition Specified Condition

        Battery positive (+) → Terminal 11 (ACC)

        Battery negative (-) → Terminal 12 (GND1)

        		 Mobile wireless charger switch is on (not protruding) Switch indicator light illuminates
        Mobile wireless charger switch is off (protruding) Switch indicator light does not illuminate

        If the result is not as specified, replace the mobile wireless charger switch.

    3. Check that the switch illuminates.


      1. A01HYKJE04
        Text in Illustration
        *a

        Component without harness connected

        (Mobile Wireless Charger Switch)

        Apply battery voltage to the mobile wireless charger switch and check that the switch illuminates.

        OK
        Connection Specified Condition

        Battery positive (+) → Terminal 10 (ILL+)

        Battery negative (-) → Terminal 9 (ILL-)

        		 Illuminates

        If the result is not as specified, replace the mobile wireless charger switch.