POWER WINDOW CONTROL SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

    System Name See Procedure
    Parking Assist Monitor System

    Click here

  2. IGNITION SWITCH EXPRESSIONS


    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression Ignition Switch (Position) Engine Switch (Condition)
      Ignition Switch off LOCK Off (Lock)
      Ignition Switch ACC ACC On (ACC)
      Ignition Switch ON ON On (IG)
      Engine Start START On (Start)

  3. DOOR CONTROL RECEIVER EXPRESSIONS


    1. The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Vehicle Specification Part Name in Manual Actual Part Name
      w/ Tire Pressure Warning Door control receiver Door control and tire pressure monitoring system receiver assembly
      w/o Tire Pressure Warning Door control receiver Door control receiver

  4. POWER WINDOW CONTROL SYSTEM PRECAUTIONS

    Note


    • The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly Click here.

    • The power window control system prohibits the auto up and down function when the jam protection function malfunctions.

    • If the power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) has been replaced with a new one, initialize the power window control system Click here.

    • If the power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) and door window regulator sub-assembly have been removed and installed, or if the power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) was reused when a door glass or door glass run was replaced, initialize the power window control system Click here.

    • The jam protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:


      • A power window is being opened or closed while the vehicle is driven on a rough road.

      • A power window is being opened or closed while the door is being opened or closed.

      • The voltage changes abruptly.

    • Do not disconnect the battery while the ignition switch is ON. Otherwise, DTC B2313 will be stored Click here.