SPIRAL CABLE REMOVAL


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. A01I1XS

      Check the colored part as shown in the illustration.

      Text in Illustration
      A01HYFG Colored Part

      If the colored part shown in the illustration cannot be confirmed, it is possible that the spiral cable with sensor sub-assembly is broken. Replace the spiral cable with sensor sub-assembly with a new one.

  4. REMOVE LOWER STEERING COLUMN COVER


    1. A01I1G6

      Remove the 2 screws.

    2. A01HXLM

      Push the right and left sides of the lower steering column cover, and disengage the 2 claws.

    3. A01I0NQ

      Insert a finger into the opening of the tilt lever of the lower steering column cover to disengage the claw and remove the lower steering column cover.

  5. REMOVE UPPER STEERING COLUMN COVER


    1. A01I1QC

      Disengage the 4 clips and 2 guides from the upper steering column cover.

    2. A01I0R9

      Disengage the 2 claws to remove the upper steering column cover.

  6. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch on (IG).

    • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the ignition switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

    3. Check that the front wheels are facing straight ahead.

    4. A01I198E01
      Text in Illustration
      *a Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. Disconnect the other connector from the spiral cable with sensor sub-assembly.

    6. A01HY9P

      Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.