METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the Techstream to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the Techstream on.

    6. Enter the following menus:


      1. for Combination Meter: Body Electrical / Combination Meter / Data List.

      2. for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.

      3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

      4. for Main Body: Body Electrical / Main Body / Data List.

    7. Read the Data List according to the display on the Techstream.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ODO/TRIP Change SW ODO/TRIP switch/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
      Engine Rpm Engine speed/Min.: 0 rpm, Max.: 12750 rpm Almost the same as actual engine speed -
      Coolant Temperature Engine coolant temperature/Min.: 0°C (32°F), Max.: 127.5°C (261.5°F) 75 to 100°C (167 to 212°F): After warming up engine -
      Washer Switch Washer fluid level warning switch/OFF or ON OFF: Washer fluid level not low -
      ON: Washer fluid level low
      Check Engine SW MIL (Check engine warning light)/OFF or ON OFF: MIL (Check engine warning light) off -
      ON: MIL (Check engine warning light) on
      Light Control Switch Light control rheostat switch/OFF or ON OFF: Switch released -
      ON: Switch pushed
      +B Voltage Value Battery voltage/Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      Integrated Value for Oil Maintenance*1 Maintenance required reminder value/Min.: 0 miles, Max.: 25500 miles Driving distance after performing maintenance required reminder reset procedure displayed If the value is 5000 (miles) or more, perform the maintenance required reminder reset procedure after performing maintenance.
      Fuel Input Fuel input/Min.: 0 L, Max.: 127.5 L Fuel receiver gauge indicates F: 57.9 Unit: Liter
      Fuel receiver gauge indicates 3/4: 45.6
      Fuel receiver gauge indicates 1/2: 32.2
      Fuel receiver gauge indicates 1/4: 18.9
      Fuel receiver gauge indicates E: 6.4
      Ambient Temperature Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
      Multi Switch (Up)*2 Steering pad switch (Up)/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Down)*2 Steering pad switch (Down)/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Enter)*2 Steering pad switch (Enter)/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Multi Switch (Right)*2 Steering pad switch (Page)/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Oil Pressure Switch Oil pressure switch/OFF or ON OFF: Engine started -
      ON: Engine not started
      Turn Signal Switch (Right) RH turn signal switch/OFF or ON OFF: RH turn signal switch off -
      ON: RH turn signal switch on
      Turn Signal Switch (Left) LH turn signal switch/OFF or ON OFF: LH turn signal switch off -
      ON: LH turn signal switch on
      Hazard Flasher Switch Hazard warning signal switch/OFF or ON OFF: Hazard warning signal switch off -
      ON: Hazard warning signal switch on
      Headlight Auto Leveling Switch*3 Headlight leveling warning/OFF or ON OFF: "Check Headlight Leveling System" not displayed -
      ON: "Check Headlight Leveling System" displayed
      Turn Switch Signal (Full Turn) LH or RH turn signal switch/OFF or ON OFF: LH or RH turn signal switch off -
      ON: LH or RH turn signal switch on
      Multi Switch (Back)*2 Steering pad switch (Back)/OFF or ON OFF: Switch released -
      ON: Switch pushed
      Key Remind Sound Cycle of the key reminder warning buzzer/Normal, Slow, Fast Displays customize setting of key remind sound -
      Driver Side Seatbelt Warning Buzzer Setting of the driver seat belt warning buzzer/OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened Displays customize setting of Driver Side Seatbelt Warning Buzzer
      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened
      P-Seatbelt Warning Buzzer Setting of the front passenger seat belt warning buzzer/OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened Displays customize setting of Front Passenger Side Seatbelt Warning Buzzer
      ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger seat belt unfastened
      ODO Display Time After IG OFF Setting Setting of the ODO display time after the ignition switch is turned off/30s, 60s, 600s, OFF Displays customize setting of ODO Display Time After IG OFF setting -
      Lane Change Flashing Times Setting Setting of the lane change flashing times/OFF, 3, 4, 5, 6, 7 Displays customize setting of Lane Change Flashing Times Setting -
      LDA System Existence of function/With or Without With: w/ Lane departure alert system -
      Without: w/o Lane departure alert system
      PCS System Existence of function/With or Without With: w/ Pre-collision system -
      Without: w/o Pre-collision system
      Radar Cruise System Existence of function/With or Without With: w/ Dynamic radar cruise control system -
      Without: w/o Dynamic radar cruise control system
      Number of Trouble Code The number of DTCs currently stored/Min.: 0, Max.: 255 0 -

      • *1: for Speedometer with Imperial Units for Main Scale

      • *2: w/ Multi-information Display

      • *3: w/ Automatic Headlight Beam Level Control System

      ABS/VSC/TRAC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
      Engine and ECT
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Injection Volume (Cylinder 1) Injection volume (cylinder 1)/Min.: 0 ml, Max.: 2.047 ml 0 to 0.5 ml

      • Stored as Freeze Frame Data

      • This is the fuel injection volume for 10 injections.

      Results of real-vehicle check:


      • Idling (engine warmed up): 0.108 ml

      • Running without load (3000 rpm): 0.097 ml
      Engine Speed Engine speed/Min.: 0 rpm, Max.: 16383 rpm

      • 610 to 710 rpm: Idling (for 2AR-FE)

      • 600 to 700 rpm: Idling (for 2GR-FE)

      • Stored as Freeze Frame Data

      • When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.

      Results of real-vehicle check:

      Idling (warm up the engine and A/C off): 660 rpm
      Coolant Temp Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up

      • Stored as Freeze Frame Data

      • This is the engine coolant temperature.

      Tech Tips


      • After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

      • After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.

      • If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

      • Check if the engine overheats when the value indicates higher than 135°C (275°F).
      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Illumination Rate Info Illumination rate information/0 ms. to 2162.65 ms. Value output according to ambient light level -

  2. ACTIVE TEST

    Tech Tips

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the Techstream on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the Techstream.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0, 40, 80, 120 mph*1

      There is a deviation in the values displayed on the speedometer

      (Control range → Speedometer display)


      • 40 → 39.5 to 43.0

      • 80 → 79.5 to 84.0

      • 120 → 119.5 to 125.0
      0, 40, 80, 120, 160, 200, 240*3 km/h*2

      There is a deviation in the values displayed on the speedometer

      (Control range → Speedometer display)


      • w/o Side Turn Signal Light:


      • 40 → 39.0 to 43.0

      • 80 → 79.0 to 85.0

      • 120 → 120.0 to 126.0

      • 160 → 160.0 to 168.0

      • 200 → 200.0 to 210.0


      • w/ Side Turn Signal Light:


      • 40 → 41.7 to 46.2

      • 80 → 83.4 to 88.4

      • 120 → 125.1 to 130.6

      • 160 → 166.2 to 173.2

      • 200 → 207.7 to 215.7
      Tacho Meter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 -
      Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F -
      Fuel Consumption Meter Operation*3 Fuel consumption meter OFF, MIN, 1/4, 1/2, 3/4, MAX -
      A/T Indicator Operation 1 Shift position indicator OFF, L, 2, 3, 4, D, N, R, P -
      A/T Indicator Operation 2 Shift position indicator OFF, 8, 5, 6, 7, S -
      A/T Indicator Operation 3 Shift position indicator OFF, D -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open*3 Door open warning light OFF or ON -
      Indicat. Precrash*4 PCS OFF warning light OFF or ON -
      Driver Side Seat Belt Driver or front passenger seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge*3 Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Head*1 Head indicator light OFF or ON -
      Indicat. Lamp Tail*2 Tail indicator light OFF or ON -
      Indicat. Lamp Washer*3 Washer fluid level warning light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      VSC TRC Indicator*3 TRAC OFF indicator light OFF or ON -
      Indicat. Tire Pressure Warning System*7 Tire pressure warning light OFF or ON -
      Indicat. Oil Pressure*3 Engine oil pressure warning light OFF or ON -
      Indicat. ECONO Eco driving indicator light OFF or ON -
      Indicat. Lamp Cruise*3 Cruise control indicator light (green) OFF or ON -
      Indicat. Lamp Brake Brake warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Indicat. Oil Maintenance*1, *3 Maintenance required reminder indicator light OFF or ON -
      Master Warning*5 Master warning light OFF or ON -
      Indicat. SET*3 Cruise control SET indicator light OFF or ON -
      Indicat. VSC OFF VSC OFF indicator light OFF or ON -
      Cruise Indicator*3 Cruise control indicator light (amber) OFF or ON -
      Automatic High Beam Indicator*6 Automatic high beam indicator light OFF or ON -
      Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
      Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
      Check Engine Indicator MIL (Check engine warning light) OFF or ON -
      Water temperature meter operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH -
      Meter Display 1 Multi-information display*5 OFF, All -
      LCD display*3 OFF, 0, 1, 2, 3, 4, 5, 6, All
      Meter Display 2*3 LCD display OFF, 7, 8, 9 -

      • *1: for Speedometer with Imperial Units for Main Scale

      • *2: for Speedometer with Metric Units for Main Scale

      • *3: w/o Multi-information Display

      • *4: w/ Pre-collision System

      • *5: w/ Multi-information Display

      • *6: w/ Automatic High Beam System

      • *7: w/ Tire Pressure Warning System