ELECTRICAL KEY OSCILLATOR (for Center Floor) REMOVAL


  1. REMOVE REAR SEAT CUSHION ASSEMBLY


    1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

      Note

      Follow the instructions below carefully as the cushion frame can be deformed easily.


      1. A01I27UE01

        Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.

        Standard Measurement
        a 100 mm (3.94 in.) or less

      2. Repeat the step above for the other hook.

    2. Remove the rear seat cushion assembly.

  2. REMOVE REAR SEAT CUSHION LOCK HOOK


    1. A01HXMA

      Disengage the claw and remove the rear seat cushion lock hook.

      Note

      Rear seat cushion lock hooks must not be reused.

      Tech Tips

      Use the same procedure for the RH side and the LH side.

  3. REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    1. A01HYR5

      Disconnect the connector.

    2. Disengage the clamp and remove the No. 2 indoor electrical key antenna assembly.

      Note

      Be careful when removing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.