REAR BRAKE FLEXIBLE HOSE INSTALLATION

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.


  1. INSTALL REAR FLEXIBLE HOSE


    1. A01I1LZE02
      Text in Illustration
      *a Lock Hole

      Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      33 N*m  { 340 kgf*cm, 25 ft.*lbf }

      Note

      Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

    2. A01I15GE01
      Text in Illustration
      *1 Brake Line
      *2 Clip
      *3 Bolt
      *a Torque Wrench Fulcrum Length

      Install the rear flexible hose with the bolt.

      Torque:
      19 N*m  { 192 kgf*cm, 14 ft.*lbf }

    3. Install a new clip.

      Note

      Install the clip as far as it will go.

    4. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      Specified Tightening Torque
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length for the torque wrench Click here.

      • When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 250 mm (9.84 in.)):

        14 N*m (142 kgf*cm, 10 ft.*lbf)

  2. BLEED BRAKE LINE

    Click here

  3. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }