REAR BRAKE DISASSEMBLY


  1. REMOVE CYLINDER BOOT


    1. A01HYXQE01
      Text in Illustration
      *1 Vinyl Tape

      Using a screwdriver with its tip wrapped with vinyl tape, remove the rear disc brake piston set ring and cylinder boot from the rear disc brake cylinder assembly.

      Note

      Be careful not to damage the rear disc brake piston or rear disc brake cylinder.

  2. REMOVE REAR DISC BRAKE PISTON


    1. A01I0Q7

      Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder.

    2. Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.

      CAUTION:

      Do not place your fingers in front of the rear disc brake piston when using compressed air.

      Note

      Do not allow any brake fluid to spatter.

  3. REMOVE PISTON SEAL


    1. A01I1ODE01
      Text in Illustration
      *1 Vinyl Tape

      Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the disc brake cylinder.

      Note

      Do not damage the inner surface or piston seal groove of the cylinder.

  4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

  5. REMOVE REAR DISC BRAKE BLEEDER PLUG