VEHICLE STABILITY CONTROL SYSTEM Brake Warning Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter assembly via CAN communication.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM

   
   

   1. Check if a CAN communication system DTC is output Click here.

      Result
      Result Proceed to DTC is not output. A DTC is output. B

   
   

   B

   INSPECT CAN COMMUNICATION SYSTEM Click here

   A

2. CHECK BRAKE WARNING LIGHT

   
   

   1. Disconnect the skid control ECU connector.

   2. Turn the ignition switch to ON.

   3. Check that the brake warning light comes on.

      OK
      The brake warning light comes on.

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts Click here.

   
   

   NG

   INSPECT COMBINATION METER ASSEMBLY Click here

   OK

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

3. INSPECT COMBINATION METER ASSEMBLY

   
   

   1. Turn the ignition switch off.

   2. Reconnect the skid control ECU connector.

   3. Perform an Active Test of the combination meter assembly (meter CPU) using the Techstream Click here.

   4. Check the combination meter assembly.

      OK
      The brake warning light turns on or off in accordance with the Active Test operation.

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts Click here.

   
   

   NG

   REPLACE COMBINATION METER ASSEMBLY Click here

   OK

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here