FRONT LOWER SUSPENSION ARM (for 2GR-FE) INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY


    1. Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.

    2. A01HY1QE01

      Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.

      Torque:
      Bolt 1, 2
      200 N*m  { 2039 kgf*cm, 148 ft.*lbf }
      Bolt 3
      135 N*m  { 1377 kgf*cm, 100 ft.*lbf }

      Note

      While keeping the nut from rotating, tighten the bolt.

  2. INSTALL ENGINE MOUNTING INSULATOR (When Not Using the Engine Support Bridge)


    1. Temporarily install the engine mounting insulator LH with the 3 nuts.

      Tech Tips

      Perform this procedure only when replacement of the engine mounting insulator LH is necessary.

  3. INSTALL FRONT FRAME ASSEMBLY

    When Using the Engine Support Bridge: Click here

    When Not Using the Engine Support Bridge: Click here