SHIFT PADDLE SWITCH REMOVAL

Note


  • Do not replace the spiral cable with the battery connected and the ignition switch on.

  • Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch on.

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

  • Do not remove the steering sensor from the spiral cable.


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. A01I1CFE01
      Text in Illustration
      *a Matchmark

      Remove the steering wheel assembly set nut.

    2. Put matchmarks on the steering wheel assembly and steering main shaft.

    3. Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.

    4. A01HYFQE01
      Text in Illustration
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE STEERING PAD SWITCH ASSEMBLY


    1. Disconnect the steering pad switch connector from the spiral cable sub-assembly.

    2. w/ Shift Paddle Switch Wire of Steering Pad Switch Assembly:


      1. A01I0HZ

        Disengage the clamp.

    3. w/ Shift Paddle Switch:


      1. Disconnect the No. 1 switch wire connector.

    4. A01I1BCE01
      Text in Illustration
      *1 Pin
      *2 Guide

      Remove the 2 screws.

    5. Disengage the 2 claws, 2 pins and 2 guides to remove the steering pad switch assembly.

  5. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    A01HZ3W

    1. Remove the 2 screws.

    2. Disengage the 4 pins and remove the 2 shift paddle switches (transmission shift switch assembly).

  6. REMOVE NO. 1 SWITCH WIRE


    1. A01HXRK

      Disengage the 5 guides to remove the shift paddle switch (transmission shift switch assembly) with No. 1 switch wire from the steering wheel assembly.

    2. A01HYWFE01
      Text in Illustration
      *1 Clamp

      Remove the 2 clamps.

    3. Disconnect the 2 connectors to remove the 2 shift paddle switches (transmission shift switch assembly) from the No. 1 switch wire.