DYNAMIC RADAR CRUISE CONTROL SYSTEM Cruise SET Indicator Light Circuit

DESCRIPTION

• The ECM turns on the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication.

• The cruise control SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed.

• The cruise control SET indicator circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

WIRING DIAGRAM

Refer to cruise control indicator circuit Click here.

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (METER DISPLAY 1)

   
   

   1. Connect the Techstream to the DLC3.

   2. Turn the engine switch on (IG).

   3. Turn the Techstream on.

   4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

   5. According to the display on the Techstream, perform the Active Test.

      Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Meter Display 1	Multi-information display	OFF or All	-

      OK
      The cruise control SET indicator light goes on or off.

   6. Turn the engine switch off.

   
   

   NG

   REPLACE COMBINATION METER ASSEMBLY Click here

   OK

   REPLACE PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here