LANE DEPARTURE ALERT SYSTEM Power Source Circuit

DESCRIPTION

This circuit provides power to operate the lane departure warning camera.

WIRING DIAGRAM

A01HZ5SE02

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK TERMINAL VOLTAGE (POWER SOURCE OF LANE DEPARTURE WARNING CAMERA)


    1. A01I25DE08
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Lane Departure Warning Camera)

      Disconnect the S21 lane departure warning camera connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      S21-7 (IGB) - Body ground Engine switch on (IG) 11 to 14 V
      S21-7 (IGB) - Body ground Engine switch off Below 1 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      S21-11 (GND) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here