INTAKE AIR CONTROL VALVE ACTUATOR (for TCV) INSTALLATION


  1. INSTALL INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)

    Note


    • A01I1KU

      Make sure that foreign matter, such as water, oil, sand or iron particles, does not enter the gear chamber or actuator at the locations marked by the circles in the illustration.

    • A01I0PB

      Do not loosen or remove the bolt and 2 nuts shown in the illustration.


    1. A01HZ0WE02
      Text in Illustration
      *a Condition: Closed

      Check the tumble control valves.

      Tech Tips

      If the tumble control valves are not closed, close them by hand.

    2. A01I0XHE02
      Text in Illustration
      *a Condition: Closed

      Check that the gear of each tumble control valve is in the position shown in the illustration.

      Tech Tips

      Turn the gear clockwise until it contacts the stopper.

    3. Install a new gasket to the intake air control valve actuator.

    4. Install the intake air control valve actuator to the intake manifold with the 2 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • If excessive force is applied to the gear in the direction of rotation when installing the actuator, the valves and actuator may be damaged.

      • After installing the actuator, make sure that the ends of the valves are not protruding from the surface where the intake manifold is installed. If the valves are protruding, remove and reinstall the actuator.

  2. INSTALL INTAKE MANIFOLD

    Click here