CANISTER REMOVAL


  1. REMOVE FUEL TANK ASSEMBLY

    Click here

  2. REMOVE CHARCOAL CANISTER ASSEMBLY


    1. A01HXP1E01

      Disconnect the purge line hose.

    2. Disconnect the connector from the charcoal canister leak detection pump sub-assembly.

    3. Disconnect the air line tube.

      Text in Illustration
      *1 Tube Connector
      *2 O-ring
      *3 Pipe (charcoal canister leak detection pump sub-assembly)
      *a Pinch
      *b Push

      Note


      • Remove any dirt or foreign matter on the tube connector before performing this work.

      • Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connector has an O-ring that seals the pipe.

      • Perform this work by hand. Do not use any tools.

      • Do not forcibly bend, twist or turn the air line tube.

      • Protect the disconnected parts by covering them with plastic bags after disconnecting the air line tube.

      • If the tube connector and pipe are stuck, push and pull on them to release.


      1. Push the air line tube firmly toward the charcoal canister side.

      2. Pinch the air line tube as shown in the illustration.

      3. Pull out the air line tube.

    4. A01HZT0

      Remove the 3 bolts and guide.

    5. Separate the clip from the body to remove the charcoal canister assembly.

  3. REMOVE CHARCOAL CANISTER BASE BRACKET


    1. A01I254

      Disengage the claw and remove the charcoal canister base bracket.

  4. REMOVE CHARCOAL CANISTER SUPPORT BRACKET


    1. A01HYN5

      Disengage the claw and remove the charcoal canister support bracket.

  5. REMOVE CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY


    1. Before removing the charcoal canister leak detection pump sub-assembly, clean the canister by blowing air into it to ensure that the canister is free of foreign matter.

      Note


      • Make sure to clean the canister using only air.

      • Do not use gasoline, thinners or solvents.

    2. A01HXIK

      While disengaging the 2 claws as shown in the illustration, push the charcoal canister leak detection pump sub-assembly upwards using a screwdriver to remove it.

    3. Check if the canister contains foreign matter such as mud or water.


      1. A01I17Z

        Visually check that the inside of the canister is free of foreign matter.

      2. Hold the canister upside down to make sure that the canister is free of foreign matter.

        If the canister contains foreign matter, replace the canister.